Sculpt close-up 3
More scratches and texturing. You can see across the top where I carved grooves in preparation for the EL wire I would be fitting onto it later, so that it would sit snugly.
Also, I didn't get a very good photo of it but it's the only one I have - the vials progress a bit. The plastic tube is covered at the ends with styrene, and welded with dichloromethane, a plastic solvent. I suggest using a normal glue unless you already have access to this, as it is rather dangerous.
The vials are removable rather than part of the sculpt because once I mould them, the round parts would create undercuts which means they would be very difficult to remove the sculpt from the finished mould. So instead I create them separately, to add to the mask once it's cast.